HOME | DD

Description

1 : Safety & Power On/Off
2 : Beam Width
3 : Beam Intensity
4 : Stun / Kill Select Blue Stun / Red Kill\
5 : Recharge Indicator
6 : Power Cells Remaining

When each individual on board power cells are drained, their corresponding indicator light will go red at the front of the unit. When the cells are all nearly completely drained, indicator 6 will begin flashing.

Tap the Stun / Kill indicator to set this setting. Stun is the default setting.

Tap the safety button to set it for safe. Hold for 1 second to disengage safety. This prevents accidental discharge when holstering or storing the Phaser.

To set the beam width, one only has to tap the indicator to set or reset the desired width of the beam.
That also applies to the intensity indicator.

To power on the Phaser when off, merely hold button number 1 four four seconds until the unit lights up. When powering off hold the button again for four seconds until unit goes dark. When on, tap to set safety on and off.

For forced chamber explosion in extreme situations, hold buttons 1, 2, 3, and 4 for five seconds. All the lighted indicators will begin flashing. Fifteen seconds later the Sarium Krelide power cells will overload and explode. To stop this once activated, tap button number 1 three times quickly.

This lay out is standard on all Phaser rifles.

Description

1 : Safety & Power On/Off
2 : Beam Width
3 : Beam Intensity
4 : Stun / Kill Select Blue Stun / Red Kill\
5 : Recharge Indicator
6 : Power Cells Remaining

When each individual on board power cells are drained, their corresponding indicator light will go red at the front of the unit. When the cells are all nearly completely drained, indicator 6 will begin flashing.

Tap the Stun / Kill indicator to set this setting. Stun is the default setting.

Tap the safety button to set it for safe. Hold for 1 second to disengage safety. This prevents accidental discharge when holstering or storing the Phaser.

To set the beam width, one only has to tap the indicator to set or reset the desired width of the beam.
That also applies to the intensity indicator.

To power on the Phaser when off, merely hold button number 1 four four seconds until the unit lights up. When powering off hold the button again for four seconds until unit goes dark. When on, tap to set safety on and off.

For forced chamber explosion in extreme situations, hold buttons 1, 2, 3, and 4 for five seconds. All the lighted indicators will begin flashing. Fifteen seconds later the Sarium Krelide power cells will overload and explode. To stop this once activated, tap button number 1 three times quickly.

This lay out is standard on all Phaser rifles.