HOME | DD
Spurt-Reynolds β Devastator 3
Published: 2012-09-15 19:58:07 +0000 UTC; Views: 3177; Favourites: 50; Downloads: 335
Redirect to original
Description
Straight up reapint of TFC's amazing Hercules done with Vallejo AcrylicsRelated content
Comments: 7
π: 0 β©: 0
has anyone here figured out away to combine all the parts together from the rage of hercules add on set to create a heavily armored decepticon roller combat drone scout vehicle?
now this is just how i did it but i took the gun and shoulder exstension parts from the rage set , folded the plug stud parts out from the bottom of each shoulder block part and connected them on to each side of the gun
these parts used like this form the main cannon for the combat drone
i then used both of the hercules gun stock handles from mad blender and also used the gun stock handle of the gun from the rage set to use as connector points to attach the two lower arms together side by side from the add on set.
if you take a look at the side of the rage add on sets lower arms you will notice a set of holes on each side of the lower arms on the wrist side of each lower arm
what i did is that i used the gun stock handles from madblender to connect the lower arms together side by side at the wrist end and the gun stock handle on the gun from the rage of hercuels set to connect them together side by side on the elbow end
to do this the grey colored parts on top of the rage lower arms elbows also had to be pluged into place on each side of the rage gun as the plug studs on the grey parts can be plugged into the hole on the back end of the rage gun on each side
using these parts like this the rage sets lower arms actually hold together very well in a snug solid manner as they are used to form the main body parts of the combat drone vehicle mode
if you look at the bottom side of the hercules wing plate parts from madblender you wil notice thate there are two centers holes molded into place
i used the center hole under the bottom back half of the center chest part piece to plug the entire assembled wingplate into place on topof the back half of the rage gun using the plug stud there as the connector point
with the wings folded straight up and rotated back a quarter turn the purple wing parts double as rear mounted missiles as well
while the purple colored hercules fists from neckbreaker and exgraver can be left plugged into place at the wrist tribarrol connector plug hole ports on the wrist end of the rage lower arms
to give the combat drone a set of actual wheels i salvaged a set of parts from a cybertron defense red alert figure i hand in my junk parts bin which was incomplete and very much stripped down for spare parts originally
the parts i salvaged are those parts that fold down onto the sides of cybertron red alerts lower legs which have the dual rear set of wheels mounted to them
the reason i salvaged them was because they are the perfect size plug stud for them to be able to connect into place on the outer sides of the lower arms from the rage of herculese add on set
the stud plugs on the cybertron red alert parts plug into the top hole on the wrist side on the outside of each lower arm
as for the individual tfc constructicons weapons i mounted dr cranks and exgravers guns on the shoulder block parts
with structors and heavylabours guns mounted into place on the central plug stud on the grey colored parts of the rage lower ars elbows
with the madblender and neckbreaker parts combined together using neckbreakers gun to exstend madblendrs gun with the back center hole on madblenders gun being used to conenct it to that fold out plug stud post on the back of the rage of hercules gun
all together it looks like all the parts can be used to form a very believable looking heavily armored and heavily armed decepticon roller drone combat vehicle i call destructicon
π: 0 β©: 0
