HOME | DD
IMArran — Power Rig Design
Published: 2013-07-23 22:33:18 +0000 UTC; Views: 4360; Favourites: 38; Downloads: 68
Redirect to original
Description
After a few months of being exceedingly busy, I was finally able to finish the mesh Power Rig model. This design is sleeker than the previous cylindrical one I did long ago. This one runs flush from the nape of the neck to about mid-back. The power core in the center will slowly drain until the core ejects, requiring someone to insert a new core. Good for those robotic and gynoid drones out there in SL! I will be doing more texturing on this soon, but the main mesh model is done! Woot!Related content
Comments: 4
This rig is kind of the upgrade to the current KPU system. I made this one sleeker and it is very low profile. The main core (the purple glowing part) will slowly drain over time until it completely empties, shutting the wearer down until a new power core is inserted. The power core itself will eject from the rig, where someone can then grab it and put a new one in. Once the new power core is seated into the rig, the wearer is able to move around again. It is mainly a plasma power battery for robotic and gynoid models inside of SL.
👍: 0 ⏩: 1
Ok, so it ejects itself from the sub and then recharges itself, so someone can insert it?
How does that work on land where you can't ress?
👍: 0 ⏩: 0