HOME | DD

Amansrza [2016-10-27 03:45:21 +0000 UTC]

Hi! First, I'd like to say a massive thank you for the tutorial! My only question is to do with the maths for the 'middle step' and 'flare width' sections. I've made a spreadsheet using your numbers to check it worked for me, and I've got a few issues:
1. Summing the rounded choker bottom edges, it comes to 15.7", and dividing by 6.28 (or the 2*pi which I'm assuming it is as a complete number) you get roughly 2.5", not 2.2" so I'm not sure where the 2.2" comes from.
2. For the 'middle step' numbers I have to divide the bottom edge number by the choker ratio, not multiply them like it says in the instructions (i.e. 1.5/0.444=3.4 because 1.5*0.444=0.666).
3. Following the method, I can't make my numbers for pieces 3 and 4 match what's in your table (though the sum of all my numbers adds up to 32", which matches your total length of the outer radius of your fabic 'donut'). My numbers are as follows:
          'Middle step' = 1.539 (#3) and 2.253 (#4)
          'Flare width' = 1.771 (#3) and 2.594 (#4)
If you could clear any of this up for me it would be amazing thanks! I really want to have a go at this, but can't until I figure out where I've gone wrong.

👍: 0 ⏩: 0

Lhyllianna [2016-10-17 01:41:42 +0000 UTC]

You beautiful human being. Thank you, so, so much. 

👍: 0 ⏩: 0

LovelyGeek16 [2016-07-11 05:31:15 +0000 UTC]

Hi! This was very helpful! Is there anyway you could post more Pyrrha cosplay tutorials?

👍: 0 ⏩: 1

tayyrawr [2015-10-23 01:22:56 +0000 UTC]

This is so helpful, oh my word. I really love your 'neck brace' and I'm so thankful you made a pattern for it ! I just have a (hopefully) quick question, I'm a little confused by the hairline to base of jaw/chin measurements and was wondering if there was a way you can clear it up a bit? For the chin one is it similar to the hair/to clavicle measurement, where you'd take it from the back? Thank you!!!

👍: 0 ⏩: 1