HOME | DD
sharp-n-pointy — Revolver 2-ish
Published: 2007-08-10 16:51:37 +0000 UTC; Views: 9425; Favourites: 161; Downloads: 403
Redirect to original
Description
This originally started out as just a technical drawing of the MP-412 revolver until about half way when I decided that polymer piece of cr@p could go do naughty things to itself.. so I changed it around, gave solid piece it hammer that most likely wont break off, and a steel frame with new trigger, and guard...Meh not my favorite but considering I went 3 or so months with no progress then turned around and finished it I fiquired if I dont post it my hard drive will kill me for the loitering.
TOP IS 6" VERSION, LOWER IS THE 'DETECTIVE' VERSION IN 4"
Related content
Comments: 10
I Really want one of these in real life, but they're pretty much impossible to get in the US, as far as I know
👍: 0 ⏩: 0
thanks i have been looking for a detailed image of the rex revolver for a while and this one is awesome.
👍: 0 ⏩: 0
Nice. I like the designs. Clean and detailed.
But...
Curious about where the cylinder release is, and afraid that the little nub below the trigger would pinch the finger when letting off the trigger...
👍: 0 ⏩: 1
That nub is to help with finger indexing as it guides the finger onto the trigger, secondly one should squeeze the trigger from the center, not the toe (the bottom part) removing the issue of pinch-age
👍: 0 ⏩: 1
